|
Metal Stamping Punch
Scallop Edge Wave Design
Customize Any Metal Blank
1 Tool - Stamp any flat, soft metal.
- Use this punch to personalize metal blanks (made from non-ferrous metals such as Sterling Silver, Copper, Vintaj Natural brass and more).
- 6mm (1/4 Inch) height design.
- Made of tempered steel for years of service.
- Use with a metal bench block or anvil and a 16 ounce flat head hammer.
- Hold your blank in place on a bench block using simple masking tape. The masking tape can also act as a guide to assure your design is in the right spot.
- Measurements: Punch is 3" in length. Design length for this piece is approximately 6mm (1/4 Inch).
- Quantity: 1 stamp in one pattern.
|
