|
Eurotool Elite Design Series
Metal Stamping Punch
DOG PAW DESIGN
Customize Any Metal Blank
1 Tool - High quality metal punch for decorating flat, soft metal. Design is printed on the side of the punch, allowing you to quickly identify the correct punching position. The printed design will always be the bottom of the stamped design.
- Use this punch to personalize metal blanks (made from non-ferrous metals such as Sterling Silver, Copper, Vintaj Natural brass and more).
- 5mm (1/5 Inch) design.
- Made of tempered steel for years of service.
- Use with a metal bench block or anvil and a 16 ounce flat head hammer.
- Hold your blank in place on a bench block using simple masking tape. The masking tape can also act as a guide to assure your design is in the right spot.
- Measurements: Punch is 3" in length. Design height for this piece is approximately 5mm (1/5 Inch) with 4.5mm width.
- Quantity: 1 stamp in one pattern.
|
