Retired - La Peregrina

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Evenly spread a small amount of E6000 on the back of the pearl cabochon using a toothpick or a piece of wire and press it firmly onto the center of the filigree stamping. Let it set for a few minutes before moving on to the next step.
2. Once the glue on the cabochon has set, glue a row of the larger Jet Nut Austrian crystal rhinestones directly next to each other and directly next to the cabochon. Let these set for a few minutes.
3. Now glue a row of the small Caribbean Blue Opal Austrian crystal rhinestones onto the outer edge of the filigree, one per "bump" in the scalloped edge. Allow everything on the front of the filigree to dry completely (at least a few hours) before moving on to the next step.
4. Once the items are securely glued to the face of the filigree, you must glue the pin back onto the other side. Allow to set for twenty-four hours before wearing.

• FCO-7000 -
  Project uses 1 piece. You will need 1 package.


• SWF-11617 -
  Project uses 19 pieces. You will need 1 package.


• SWF-40925 -
  Project uses 24 pieces. You will need 1 package.


• FCO-9042 - Silver Tone Glue On Bar Pin Back 1 1/2 Inch (39mm) (24 Pieces)
  Project uses 1 piece. You will need 1 package.


• XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
  Project uses 1 piece. You will need 1 package.