|
The Vara Bracelet
Project B109
Designer: Amanda Nistor
The subtle warmth of antique copper meets the deep sparkle of Swarovski in this pretty bracelet.
|
What You'll Need
Purchase All Supplies
|
Instructions:
- Cut five pieces of wire at two inches each.
-
Thread one end of one of the lengths of wire through the loop on the circular part of the toggle clasp and create a wrapped loop.
-
On the same piece of wire thread a Bali copper daisy, an 8mm Swarovski bead, and another copper daisy. Thread the wire through one of the loops on a rivoli bezel. Create a wrapped loop and trim off excess wire.
-
On the other loop of the same rivoli bezel thread another piece of wire and create a wrapped loop.
-
On the same piece of wire thread a Bali copper daisy, an 8mm Swarovski bead, and another copper daisy. Thread the wire through one of the loops on a rivoli bezel. Create a wrapped loop and trim off excess wire.
-
Repeat this process until you use all four rivoli bezels and all five 8mm beads. On the last 8mm bead segment create a wrapped loop without threading it though anything.
-
Add a jump ring to the final wrapped loop and another jump ring to the first one.
-
To the final jump ring add the bar part of the toggle clasp.
-
Using a toothpick, apply a small amount of the E6000 glue to the backs of the rivolis and place them in the cups of the rivoli bezels. The glue will set in about six minutes, and full drying occurs within twenty-four hours.
Tip: Check package quantities for each component. You may have extra material to make more than one finished project, or will have leftovers for other projects. In some cases, adding on just one more package of a component may be all you need to make multiple pieces.
All designs © Beadaholique Inc.
You may use our designs to make items for personal use or gifts.
Sale of our designs, whether in written form or assembled, is prohibited.
|
|
