Fields of Clover Bracelet

What You'll Need

• 14 (1 package) - Biwa Cultured Shamrock Coin Pearls Green 12mm 16 Inch Strand (PEG-7001)


• 1 (1 package) - Gun Metal Plated Curved Lobster Clasps 12mm (6) (FCL-4731)


• 1 (1 package) - Green Girl Studios Lead-Free Pewter Shamrock Lucky Charm Pendant (PND-9401)


• 1 foot - Gun Metal Curb Chain Large (CHA-2627)


• 45 (1 package) - Czech Glass Druk 4mm Round Hematite (BCP-7485)


• 15 (1 package) - Gun Metal Head Pins 2 Inches 24 Gauge (FHP-5421)


• 3 (1 package) - 6mm Open Jump Rings 19 Gauge Gunmetal Plated (FJR-5296)


• 2 (1 package) - Gun Metal Brass Crimp Beads 2mm x 1.5mm (FCR-1253)


• 2 (1 package) - Gun Metal Brass Fluted Crimp Bead Covers 4mm (FCR-1083)


• 10" (1 package) - Soft Flex Best Beading Wire .024 Inch 30 Ft (XCR-5123)

NOTE: Clicking the "Purchase All Supplies" button will order all of the above supplies. If you only need to purchase some of the items, please use the individual "Add" buttons above.

Instructions:

1. Thread each double shamrock pearl onto a headpin and create a wrapped loop on each. Trim excess wire.


2. Open a jump ring and thread it through the hole on the pewter good luck pendant. Close jump ring again.


3. Cut a piece of Soft Flex at ten inches long and secure one end with a Bead Stopper.


4. Thread a single hematite Druk onto the Soft Flex.


5. Add a pearl headpin drop and three hematite Druks.


6. Continue this pattern until you have threaded exactly half of your shamrock pearl drops.


7. Add three hematite Druks, the good luck charm, and three more Druks.


8. Thread the second half of the bracelet as a mirror image of the first.


9. Add a crimp tube, but do not crimp yet.


10. Thread the end of the wire through a jump ring and back through the crimp tube. Pull tightly and crimp.


11. Gently open the jump ring and thread it through the loop on the lobster clasp, closing the jump ring after you have done so.


12. Remover the bead stopper from the opposite end and add a crimp tube, but do not crimp it yet.


13. Thread the end of the wire through a jump ring and back through the crimp tube. Pull tightly and crimp. Open the jump ring.


14. Cut a piece of curb chain at about two and a half inches long, and add this to the jump ring, closing it after you have done so.


15. Thread a hematite Druk onto a headpin and make a loop.


16. Thread the loop through the last link of the curb chain, completing it as a wrapped loop and trimming off excess wire.


17. As a final step, add a crimp bead cover to each crimp tube and gently close. Trim off excess wire.