Bride of Dracula Earrings
Project E119
Designer: Andrea Morici
These lovely, slightly sinister earrings aren't just for Halloween! Wear them whenever you are feeling a bit
vampish.
|
What You'll Need
Purchase All Supplies
|
Instructions:
- Remember to double the instructions to make both earrings! Cut a piece of chain two and a half inches long.
-
Attach one end of the chain to one of the points on the filigree stamping using a jump ring.
-
Thread a cathedral bead onto a headpin and make a simple loop. Trim off excess wire.
-
Gently open the loop on the headpin and thread it though the last link on the other end of the chain. Close the loop again.
-
To the other point on the filigree stamping, add a jump ring. Add another jump ring to the first.
-
Thread the last jump ring through the loop on the leverback earring hook and close the jump ring.
-
Using a toothpick, dab a tiny amount of E6000 glue on the back of your rhinestone and place it in the center of the filigree stamping. The glue will set in about six minutes, but it takes up to twenty four hours to dry fully.
Tip: Check package quantities for each component. You may have extra material to make more than one finished project, or will have leftovers for other projects. In some cases, adding on just one more package of a component may be all you need to make multiple pieces.
All designs © Beadaholique Inc.
You may use our designs to make items for personal use or gifts.
Sale of our designs, whether in written form or assembled, is prohibited.
|
