Industrial Design Earrings
Project E225
Designer: Andrea Morici
Designed to look just like riveted sheet metal, these funky asymmetrical earrings are made from Vintaj Arte
Metal and Swarovski Pearl flatbacks.
|
What You'll Need
Purchase All Supplies
Specialized Tools
|
Instructions:
- Begin by lightly roughing up (in a circular motion) the surface of both arte metal stamping blanks, using fine grit sand paper or an emery board. Leave some of the original finish in spots for a mottled, industrial appearance.
-
Arrange your pearl flatbacks on each stamping blank in any way you would like, or follow the pattern we have used, as it appears in the photos.
-
Spread a tiny amount of E6000 on the back of your flatbacks, and very carefully press them into place on your stampings. Set aside to dry for a few hours.
-
. Thread two through each hole at the top of each arte metal stamping blank. Close both of these again.
-
Use the other two jump rings to add your earring hooks. Close the last two jump rings and you are finished!
|
Tip: Check package quantities for each component. You may have extra material to make more than one finished project, or will have leftovers for other projects. In some cases, adding on just one more package of a component may be all you need to make multiple pieces.
All designs © Beadaholique Inc.
You may use our designs to make items for personal use or gifts.
Sale of our designs, whether in written form or assembled, is prohibited.
|
