Buttercup Necklace

What You'll Need

• 1 (1 package) - Antiqued Brass Glue On Pendant Mounting Bails For Tile Dichroic 15mm (4) (FCO-5301)


• 1 (1 package) - Antiqued Brass Oval Filigree Stamping 35mm x 44mm (2) (FCO-7053)


• 1 (1 package) - Vintage German Glass Cameo Yellow Flowers 40mm x 30mm (1) (BCP-4160)


• 1 (1 package) - Vintaj Natural Brass Jump Rings 4mm Open 21 Gauge (25) (FJR-5340)


• 2' - Vintaj Natural Brass 2mm Delicate Curb Chain - Bulk By The Foot (CHA-7100)


• 1 (1 package) - E6000 Industrial Strength Glue Adhesive (1/2 Oz) (XTL-1053)

Instructions:

1. Begin by gently folding the scalloped edge of the stamping upward at a ninety degree angle with your chain nose pliers, creating a bezel.


2. Evenly spread a thin layer of E6000 on the back of the glass cabochon and firmly press it into the stamping bezel. Wipe off any excess glue, and set aside to dry for a few hours.


3. Once it is dry, press the edge of the bezel gently but firmly around the cabochon by rolling the edge against a hard and smooth surface, such as that of a bench block. Take care not to press to hard as to chip or break the glass cabochon.


4. Spread a small amount of E6000 onto the leaf-shaped part of the glue-on bail. Press it firmly onto the back of the pendant at the top. Set aside to dry for a few hours.


5. Finally, thread the chain through the pendant bail and, using a 4mm jump ring, join the two ends of the chain.