Marquessa Necklace

What You'll Need

• 2 (2 packages) - Swarovski Crystal #6110 30 x 14mm Navette Pendant Crystal Copper (1) (SWC-9942)


• 3 (2 packages) - Real 22K Gold Plated Lead-Free Pewter Round 20mm Connector Link Ring (2) (BMB-3343)


• 1 (1 package) - Swarovski Crystal #6110 40 x 18mm Navette Pendant Crystal Copper (1) (SWC-9961)


• 9 (1 package) - 22K Gold Plated 8mm Open Jump Rings (100) (FJR-5280)


• 4 (1 package) - 6mm Open Jump Rings 22K Gold Plated (100) (FJR-5260)


• 1 (1 package) - 22K Gold Plated Lead-Free Pewter Hammertone Ellipse Toggle Clasp 16mm (1) (FCL-7009)


• 3 (1 package) - 22K Gold Plated Pinch Bail For Gemstone & Crystal Pendants (10) (FCO-4031)


• 18" - Gold Tone Stylish 5mm x 7mm Long & Short Chain - By The Foot (CHA-1030)

Instructions:

1. Start by opening one of the bails wide enough to slip over the top of one of the larger Swarovski crystal pendants (SWC-9961). Line up the 2 small prongs on the bail with the hole of the Swarovski crystal. Gently squeeze the bail closed with your fingers. You can use a pair of nylon chain nose pliers (XTL-6020) to make a more secure fit by gently squeezing the bail together. Repeat with the other two smaller Swarovski crystals (SWC-9942). Set aside.


2. Open a large jump ring (FJR-5280). Link onto two large closed jump rings (BMB-3343). Close the jump ring. Repeat again with 2 larger open jump rings.


3. Now open another large open jump ring. Link onto the last large closed jump ring and to one of the large closed jump rings from before. (see photo)


4. Cut off two pieces of chain (CHA-1030) each measuring 7 inches in length. Open a smaller jump ring (FJR-5260). Link onto the left large closed jump rings from the assembled piece you just made and an end link of the chain (CHA-1030). Close the jump ring. Repeat for the right side.


5. Attach the T-Bar part of the toggle to one of the end links of chain with another small open jump ring (FJR-5260). Close the jump ring. Attach the toggle to the other end link of the chain with another small open jump ring. Close jump ring.


6. Now you will assemble the crystal pendants to the 3 large closed jump rings.


7. Open one of the larger open jump rings. Thread through the top loop of the bail on the largest Swarovski crystal. Link onto the bottom of the center large closed jump ring from the piece you assembled earlier (see photo). Close the jump ring.


8. Open another larger open jump ring. Thread through the top loop of the bail on one of the smaller Swarovski crystal pendants. Link onto the bottom of the left large closed jump ring. Close the jump ring. Repeat for the right side. You're finished!