Twinkle Twinkle Bracelet (Reboot)

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. If you are not already familiar with Right Angle Weave, please watch the How to Do a Flat Right Angle Weave - Single Needle video before proceeding with this project. Begin by single- threading approximately two yards of Fireline onto your needle.
2. Using the 4mm crystal AB 2x bicones, create two rows of Right Angle Weave which are approximately five and a half inches in length. This is the body of your bracelet.
3. Bringing your thread around to the outside of one of your rows, begin to add small silver beads between each of the 4mm bicones. Remember to pull tight, so that the silver beads make space between each bicone, eventually causing it to distort and curl.
4. After you finish adding the silver beads on the outside row, bring your thread to the center of the two rows, and add a silver bead between each of those bicones as well, pulling tight as you go.
5. Finally, repeat this action on the other outside row. Your bracelet should now have a spiral look to it.
6. Bring your thread up through the center of the bracelet and add a 6mm bicone at one end.
7. Guide your thread through a sterling silver thread guard and back down through the 6mm bicone bead.
8. Thread your needle down the center of the two rows and back out at the opposite end of the bracelet. Add another 6mm bicone and repeat the previous step.
9. Tie off your thread and weave in the remainder.
10. Open two sterling silver jump rings and use them to connect the toggle clasp to both ends of your bracelet.

• BMB-01220 - Sterling Silver Seamless Round Beads 2mm (24)
  Project uses 69 pieces. You will need 3 packages.


• FCL-4250 - Sterling Silver Round Adjustable 9mm Toggle Clasp 1.5 Inches (1 Clasp)
  Project uses 1 piece. You will need 1 package.


• FCR-4149 - Sterling Silver Wire & Thread Protectors Guards .031 Inch (10)
  Project uses 2 pieces. You will need 1 package.


• FJR-03046 - Sterling Silver Open Jump Rings 4mm 21 Gauge (20)
  Project uses 2 pieces. You will need 1 package.


• SWBI-1402 - Austrian Crystal, 5328 Bicone Beads 4mm, 24 Pieces, Crystal AB 2X
  Project uses 120 pieces. You will need 5 packages.


• SWBB-1602 - Austrian Crystal, 5328 Bicone Beads 6mm, 20 Pieces, Crystal AB 2X
  Project uses 2 pieces. You will need 1 package.


• XCR-1278 - FireLine Braided Beading Thread, 6lb Test and 0.006 Thick, 50 Yards, Crystal Clear
  Project uses 10 feet. You will need 1 package.

• XTL-5700 - Fiskars 5 Precision Tip Scissors - Super Sharp
• XTL-3006 - Beadsmith English Beading Needles Size 12 (4 Needles)