Retired - Canter Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Cut one 3-inch piece of faux-leather cord.
2. Set the BeadSmith leather hole punch tool to its 2mm setting. Fold the piece of cord in half, and punch a hole through both sides about 1/4-inch from the edge.
3. Slide the piece of cord through the TierraCast connector ring and realign the edges. Slide one washer bead onto your eyelet, and place the eyelet through both of the holes punched in the piece of cord.
4. Place the eyelet face-down into the notch of the anvil. Use the eyelet setting tool and hammer to fasten the eyelet.
5. Open the ball chain necklace and slide it through the bail. Your necklace is all done!

• FCO-3130 - TierraCast Antiqued Silver Plated 26mm Spiral Ring Connector Link (2)
  Project uses 1 piece. You will need 1 package.


• XCR-8028 - Flat Faux Leather Cord, 10x1.3mm, 1 Meter, Chocolate Brown
  Project uses 3 inches. You will need 1 package.


• FCO-4803 - TierraCast Antiqued Pewter Color Brass Hollow Eyelets 3.7mm Diameter, 5.2mm Long - Pack of 10
  Project uses 1 piece. You will need 1 package.


• PND-12005 - TierraCast Antiqued Pewter Micro Washer For Jewelry 6mm - Pack Of 10
  Project uses 1 piece. You will need 1 package.


• AXC-0026 - Beadaholique Ball Chain Finished Necklace, 18 1 Necklace 2.4mm Links, Stainless Steel
  Project uses 1 piece. You will need 1 package.

• XTL-5502 - BeadSmith Rotating Leather Hole Punch Tool - Creates 6 Hole Sizes!
• XTL-0293 - TierraCast Eyelet Setting Kit, Rectangle Maple Wood Block 3.75x5.5 Inches & Eyelet Setting Tool, 1 Kit
• XTL-2152 - Beadsmith Jeweler's Chasing Hammer - 1 Inch Head - Metal Smithing