Retired - Cogs and Wheels Steampunk Clock Necklace

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. The focal point of this necklace is a beautiful clock which already comes with a delicate chain tassel hanging below.
2. To start, open 1 Vintaj brass 7.25mm jump ring. Link this jump ring to the top of the clock pendant, close the jump ring.
3. Open another 7.25mm jump ring and link it to the jump ring you just attached. Close the jump ring. Open a 3rd 7.25mm jump ring and link it to the previous one. Close the jump ring. Open a 4th 7.25 jump ring and link it to the previous jump ring and also the shank at the back of your Steampunk Art Deco 22.5mm brass button. Close the jump ring.
4. Next, cut your 1 foot of antique brass cog wheel chain into two equal sections, 6" long each. It is important to have the exact same number of cog wheels on each chain length. Onto the end cog link, open and link 1 antique brass oval jump ring. Before closing the jump ring, attach it to the last 7.25mm jump ring you attached to the Steampunk button shank. Close the jump ring. Open another oval jump ring and attach it to the end cog link on the other length of cut chain. Before closing this one, attach it to the 7.25mm jump ring you attached to the Steampunk button shank - but this time attach it to the other side of the shank then the side you attached the last oval jump ring to. Close the jump ring.
5. Go to the other side of one of the cog wheel chain lengths and link another oval jump ring. Before closing this jump ring, link it to the the shank on the backside of a 15mm Steampunk Art Deco wheel button. Close the jump ring. Open another oval jump ring and link it to the end chain link on your 2 feet of antique brass long/short etched textured oval chain and also the shank of the button you just linked the cog wheel chain to. Close the jump ring.
6. Repeat the previous step on the other side of your necklace.
7. All done! Enjoy!

• CHA-98861 - Antiqued Brass Cogwheel W/ Oval Links Chain 4.7mm - By The Foot
  Project uses 1 foot. You will need 1 package.


• CHA-9971 - Antiqued Brass Long Short Etched Textured Oval Chain 6mm - Bulk By The Foot
  Project uses 2 feet. You will need 2 packages.


• FJR-3908 - Antiqued Brass Open Jump Rings Oval 4x6mm 20 Gauge x50
  Project uses 1 piece. You will need 1 package.


• FJR-5372 - Vintaj Natural Brass Jump Rings 7.25mm Open 16 Gauge (20)
  Project uses 1 piece. You will need 1 package.


• PND-0112 - Antiqued Brass Steampunk Art Deco Wheel Button 15mm (1)
  Project uses 2 pieces. You will need 2 packages.


• PND-0113 - Antiqued Brass Steampunk Art Deco Button 22.5mm (1)
  Project uses 1 piece. You will need 1 package.


• PWC-36 - Steampunk Pocket Watch Pendant -Antiqued Brass Magnifying Dome W/ Bell And Chain
  Project uses 1 piece. You will need 1 package.

• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5512 - Beadsmith Jeweller's Micro Pliers Bentnose Bent Nose