Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since
this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.
You will also need a scrap of wire or a toothpick for this project.
- Begin by using your flush cutters to cut off a length of cup chain 6 crystals long.
- Using a toothpick or a scrap of wire, add a strip of E6000 into the long rectangular channel of the bangle. Place the length of cup chain into the bezel. Move it around so that the cups are evenly spaced.
- Place a dab of E6000 into the circle bezel and place a single rhinestone into the bezel. The stone will sit high in the bezel so please make sure that you are using a good size dab of glue.
- Allow to dry overnight before wearing.
- All done!
WHAT YOU'LL NEED: (scroll down for purchase options)
- CHA-2030 - Austrian crystal Gun Metal Plated Rhinestone Cup Chain 32PP Crystal - BY FT
Project uses 1 piece. You will need 1 package.
- JB-2708 - Nunn Design Cuff Bracelet, Rectangle Bezel 28.5mm/Circle Bezel 8mm, 1 Bracelet, Antiqued Silver
Project uses 1 piece. You will need 1 package.
- SWF-43000 - Austrian Crystal, Round Flatback Rhinestone SS30 6.5mm, 25 Pieces, Crystal
Project uses 1 piece. You will need 1 package.
- XTL-1054 - E6000 Industrial Strength Glue Adhesive (0.18 fl oz)
Project uses 1 piece. You will need 1 package.
RECOMMENDED TOOLS:- XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex