Retired - Amazonite Cross Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Start by cutting off a length of 4 gemstone links with their loops in tact.
2. Open the loop of the earring post, same as you would a jump ring. Slide the length of gemstone chain on to the loop and close the loop.
3. Remove the jump ring attached to the cross charm.
4. On to the other side of the chain, open a 3mm jump ring and attach the tiny cross charm to the end. Close the jump ring.
5. Attach the earring back when you're ready to wear!

• FJR-5130 - Silver Plated Open Jump Rings 3mm (x100)
  Project uses 2 pieces. You will need 1 package.


• PND-1807 - Silver Plated Small Cross Charms 6x10mm (6)
  Project uses 2 pieces. You will need 1 package.


• FEA-02007 - Earring Posts, Dagger with Loop 15mm 12 Pieces, Silver Plated
  Project uses 2 pieces. You will need 1 package.


• CHX-1508 - Sterling Silver Wire Wrapped Gemstone Chain, Amazonite Rondelles, 3.5mm, 1 Inch
  Project uses 3 pieces. You will need 3 packages.


• FEA-1013 - Silver Plated Earring Backs (Earnuts) Med. (100)
  Project uses 2 pieces. You will need 1 package.

• XTL-5600 - Xuron Sharp Flush Cutter Pliers - Wire/Soft Flex
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers