Retired - Edgy Elegance Earrings

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Take one black stud and place a gold headpin into one one of the holes. Create a simple wire loop.
2. Take another gold headpin and repeat this previous step with the other hole in the stud.
3. Cut 8 2.5" pieces of chain. Set aside.
4. Open one wire loop slightly, and slide in four piece of chain. Close the wire loop.
5. Repeat this previous step with the other wire loop.
6. Apply a dab of E6000 onto the earring post, and place it on the center of the back of the stud.
7. Allow it to dry for at least 30 minutes.
8. Repeat all the steps to make the second earring.
9. You're all done!

• BCP-11204 - Czech Glass Beads, 2-Hole Pyramid Studs 12mm, 2 Pieces, Jet Black
  Project uses 2 pieces. You will need 1 package.


• CHA-99958 - 22K Gold Plated Slim Rolo Chain 2mm Bulk By The Foot
  Project uses 4 feet. You will need 4 packages.


• FHP-6001 - Beadalon Gold Plated Coil Dome Head Pins - 21 Gauge - 2 Inches (10)
  Project uses 4 pieces. You will need 1 package.


• FEA-1618 - 22K Gold Plated Flat 4mm Glue On Earring Posts (20)
  Project uses 2 pieces. You will need 1 package.


• FEA-1015 - 22K Gold Plated Earring Backs (Earnuts) Med. (100)
  Project uses 2 pieces. You will need 1 package.

• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose