Jack Earrings (Reboot)

Note: Components and tools listed within this INSTRUCTIONS box and the printer-friendly PDF, if available, may have been discontinued since this project was published. Refer to the PURCHASE COMPONENTS and TOOLS AND OTHER SUPPLIES sections for current availability.

1. Begin by stringing your orange bicone onto your eye pin.
2. Create a simple wire loop (at the top using your round nose pliers. Snip off any excess wire using your flush cutters.
3. Then open up a jump ring with your chain nose pliers and slide it through the simple wire loop on the bottom of your orange bicone bead. Then slide on your pumpkin charm and close the jump ring.
4. Next open up the loop in your earring hook (like you would a jump ring) and slide it onto the simple wire loop on top of your orange bicone bead. Close your earring hook back up.
5. Your earring is now ready.

• SWBB-16075 - Austrian Crystal, 5328 Bicone Beads 6mm, 20 Pieces, Hyacinth
  Project uses 2 pieces. You will need 1 package.


• FEA-3015 - Earring Hooks, Fishhook Style ttMMxttMM, 25 Pairs, Silver Plated
  Project uses 2 pieces. You will need 1 package.


• PND-5966 - TierraCast Antiqued Silver Lead-Free Charm - Jack O' Lantern Pumpkin Halloween 18mm (2)
  Project uses 2 pieces. You will need 1 package.


• FHP-6267 - Silver Plated Open Eye Pins 22 Gauge 2 Inch (x50)
  Project uses 2 pieces. You will need 1 package.


• FJR-5150 - Silver Plated Open Jump Rings 5mm 20 Gauge (x100)
  Project uses 2 pieces. You will need 1 package.

• XTL-5600 - Sharp Flush Cutter Pliers - For Cutting Beading Wire, 1 Piece
• XTL-5514 - Beadsmith Jewelry Fine Round Nose Micro Pliers
• XTL-5511 - Beadsmith Jeweller's Micro Pliers Chain Nose Flat Nose